APPX Server 4.2.a HP-UX

 

Hewlett Packard HP-UX and Itanium

 

APPX Release 4.2.a

 
Release Date: January 3, 2007

 

*** Upgrading to Release 4.2  from Release 4.1.x or earlier requires installation of all of the files listed below. It is not sufficient to update just executables and linkables. As with all new software releases, it is recommended practice to install, run, and thoroughly test the new release in a test environment, before replacing your current live system. And, of course, complete backups prior to any software upgrade are always a good idea.

Please note that there are a few additional steps that must be performed after installing APPX 4.2.x. Refer to the Installation Instructions for details.

Special Installation Note: If upgrading to this release from APPX 4.2.7 or earlier releases, the installer must scratch two files:

  • $APPXPATH/0SA/Data/PRINTER.key
  • $APPXPATH/0SA/Struct/PRINTER.dat

(Be sure to note the different paths to the files!) The installer should then run APPX and go to System Admin File Management and run create files to create a new key file for the PRINTER file.

Release Notes
Recommended  
Installation Instructions
Recommended  
Unix Install Script
Recommended 12.0KB
Common Unix Files
Required 31.4KB
Risc Data Files
Required 21.0MB
Select the Executables or Linkables for the processor you are using, either PA Risc (on HP 9000 series) or Itanium.
HP PA Risc Executables
Required 1.8MB
HP PA Risc Linkables
Optional 5.0MB
HP Itanium Executables
Required 3.7MB
HP Itanium Linkables
Optional 3.3MB

 

 

For additional information, supported customers at silver level or above may contact techsupp@appx.com.